Sharp FO-1470 - Manual (Page 64)

Sending a Fax by Automatic Dialing
62
Direct Keypad Dialing
You can also enter a full number with the number keys and then press
the START key to begin dialing. You can use this method to dial a full
number when you don’t need to speak to the other party before faxing.
1
Load the document(s).
The display will show:
READY TO SEND
• Set the resolution and/or contrast if
desired.
2
Enter the number of the receiving
machine by pressing the numeric
keys.
• If a pause is required between any
of the digits to access a special
service or an outside line, press the
REDIAL key (two seconds per
pause). The pause will appear as a
hyphen. Several pauses can be
entered in a row.
3
Check the display. If the number of
the receiving machine shown is
correct, press the START key.
• If it is not correct, press the STOP
key to backspace and clear one
digit at a time, and then re-enter the
correct digit(s).
(Example)
RESOLUTION
2 4 3 2 5 6 7
START
all-ux510A.book Page 62 Thursday, September 14, 2000 9:05 AM