Sharp FO-1470 User Manual
Page 18
Loading the Imaging Film
16
3
Take the new film out of its package,
and insert two of the gears provided
with the fax into the ends of the spool
with film. Make sure that the two tabs
on the gears fit properly into the slots
in the ends of the spool.
• Do not yet remove the band which
holds the spools together.
4
Hold the empty spool so that the end
with only one slot is on the left, and
lower the spools into the front of the
printing compartment. The gears in
the ends of the spool with film should
fit into the slots on each side of the
printing compartment.
2
If you are replacing the imaging film,
take the old film out of the printing
compartment and remove the three
(3) green gears and the green flange
from the ends of the spools.
DO NOT DISCARD THE GREEN
GEARS AND THE GREEN
FLANGE!
2 tabs
all-ux510A.book Page 16 Thursday, September 14, 2000 9:05 AM