Sharp FO-1470 User Manual

Page 131

Problems and Solutions

129

11. T

roub

hooti

Dialing and transmission problems

Problem

Solution

No dial tone when you
pick up the handset or
press the SPEAKER key.

• Make sure the handset cord is connected to the

correct jack. See Connecting the handset on page
11.

Dialing is not possible.

• Make sure the power cord is properly plugged into

a power outlet.

• Make sure that the telephone line is properly

connected to both the TEL. LINE jack and the wall
jack.

• Make sure that the fax machine is set to the correct

dialing mode for your telephone line. See
Connecting the telephone line cord on page 13.

The power is on, but no
transmission takes place.

• Make sure that the receiving machine has paper.

• Make sure that the telephone line cord is plugged

into the TEL. LINE jack, and not the TEL. SET jack.

• If the receiving machine is in manual mode with no

attendant, reception will not be possible.

• Check the display for error messages.

• Pick up the handset and check for a dial tone.

Nothing is printed at the
receiving end.

• Make sure that the document for transmission is

placed face down in the feeder.

A distorted image is
received at the other end.

• Noise on the telephone line may cause distortion.

Try sending the document again.

• Make a copy of the document on your fax machine.

If the copy is also distorted, your fax machine may
need service.

all-ux510A.book Page 129 Thursday, September 14, 2000 9:05 AM