Sub-Zero ICBBI-36RG - Manual (Page 17)

17
C O M P L E T I N G T H E I N S TA L L AT I O N
S E RV I C E I N F O R M AT I O N
If service is necessary, maintain the quality built
into your Sub-Zero unit by calling a Sub-Zero
dealer.
When calling for service, you will need the
model and serial number of your unit. Both
numbers are listed on the product rating plate
located at the top frame of the unit inside the
door. Refer to the illustration on page 3.
The information and images in this guide are the
copyright property of Sub-Zero, Inc. Neither this
book nor any information or images contained
herein may be copied or used in whole or in part
without the express written permission of
Sub-Zero, Inc.
©Sub-Zero, Inc. all rights reserved.
S E RV I C E I N F O R M AT I O N
I N S TA L L AT I O N C H E C K L I S T
The importance of the installation of the
Sub-Zero Built-In unit cannot be overempha-
sized. Proper installation is the responsibility
of the selling dealer or installer.
IMPORTANT NOTE: To ensure a safe and proper
installation, the following checklist should be
completed by the installer to ensure that no part
of the installation has been overlooked.
Any questions or problems about the installation
should be directed to your Sub-Zero dealer. You
can also visit our website, subzero.com.
I N S T A L L A T I O N C H E C K L I S T
Has the packing material been removed?
Turn the unit on. Is it operating properly?
If not, is the unit plugged in? Is the control
turned on?
Is the water supply line connected and not
leaking? Is the water supply turned on and ice
maker control on?
Has anti-tip bracket been installed securely
and properly engaging the unit?
Is the unit leveled properly on a solid, level
floor? Is the kickplate installed?
Has the drain pan been installed properly?
Are panels attached securely and properly
aligned?
Have the door(s) been aligned for proper
appearance and operation?
Does your customer understand the unit's
operation? Have you given your customer the
warranty package?
Have any installation or service problems
been noted on the product registration card?
Has the registration card been
mailed in?
Have stainless steel door(s) been inspected
for any imperfections? This is to be done
by the dealer / installer with the customer
upon completion of the installation.
NOTE: Classic, platinum and carbon stainless
steel panels are covered by a limited 60-day
parts and labor warranty for cosmetic defects.
If you are storing or disposing of your old
refrigerator or freezer, please do it safely.
Remove the doors or tightly secure the doors
closed. Child entrapment accidents can be
tragic.
WARNING