Sun Microsystems Sun Fire X2100 M2 User Manual
Page 22
18
Sun Fire X2100 M2 Server Installation Guide • August 2006
Note –
This procedure assumes that you have already completed the hardware
setup and have applied standby power for your server, as described in Chapter 1 of
this guide.
1. Verify that your DHCP server is configured to accept new media access control
(MAC) addresses.
MAC addresses are 12-digit hexadecimal strings in the format xx:xx:xx:xx:xx:xx
where x represents a single hexadecimal letter (0-9, A-F, a-f).
2. Connect an Ethernet cable to the RJ-45 NET MGT Ethernet port on your server.
See
If the SP is not using static IP addresses, it broadcasts a DHCPDISCOVER packet
with the ID of its MAC address. A DHCP server on your LAN returns a
DHCPOFFER packet containing an IP address and other information. The SP then
manages its “lease” of that IP address assigned to it by the DHCP server.
3. Obtain the SP MAC address from one of the following locations. Write down that
address for future reference.
■
CLI commands. The SP has a serial port to which you can attach a terminal
device. If you log in to the SP and enter the CLI command show /SP/AgentInfo,
the SP displays the current MAC address.
■
The Customer Information Sheet shipped with your server.
■
The system BIOS setup screen. Choose Advanced
− >
IPMI 2.0
Configuration
− >
Set LAN Configuration
− >
MAC address.
4. Obtain the SP IP address from one of the following locations. Record the IP
address for future reference.
■
CLI commands. The SP has a serial port to which you can attach a terminal
device. If you log in to the SP and enter the CLI command
show /SP/AgentInfo
, the SP displays the current IP address.
■
The system BIOS setup screen. Choose Advanced
− >
IPMI 2.0 Configuration
− >
Set
LAN Configuration
− >
IP address.
■
DHCP server log files. If you use this method, follow
and
below.
Otherwise, skip to
a. Log in to your DHCP server and view its DHCP log file.
Note –
Different DHCP server applications running on different operating systems
store these log files in different locations. Consult your DHCP system administrator
to locate the correct path to the log file.