Siemens HIPATH 1200 - Manual (Page 81)

Using Other Functions/Services
81
Step by Step
Confirming/Deactivating an Alarm
If the service personnel have activated the alarm feature
on your telephone, you will receive an alarm call when
your HiPath 1200 recognizes an alarm situation
.To acknowledge the alarm call, you must answer it. If
you do not answer the alarm call, it will be repeated (de-
pending on how it is programmed).
Precondition: "Call: Sensor..." appears on the display
and your telephone rings three times in rapid successi-
on every four seconds.
Press the key.
or
n
Lift the handset
r
Enter the code (only necessary if programmed by ser-
vice personnel; "Acknowledge Code" is active).
Press the key. The LED goes out.
or
t
Replace the handset.
Turning off an Alarm
If an additional alarm was activated for the alarm call,
this can be specifically deactivated.
rmheh
Enter the code.
o
Enter the code ("password for manager access", consult
your service personnel).
The alarm is deactivated.
Speaker
Speaker