Siemens HIPATH 1200 - Manual (Page 69)

Privacy/Security
69
Step by Step
Monitoring a Room
A telephone can be used to monitor a room. The func-
tion must be activated on the telephone that you want
to monitor.
Calling this telephone from outside lets you hear what
is going on in the room.
Activating the telephone to be monitored:
Press the key. The LED lights up.
> :
Select and confirm.
or
qll
Enter the code.
You can either leave the telephone in speakerphone
modeoptiPoint 500 economy (not available with
optiPoint 500 basic) or lift the handset and leave it direc-
ted towards the noise source.
Deactivating the telephone to be monitored:
Press the illuminated key. The LED goes out.
or
t
Replace the handset.
Monitoring the room:
n
Lift the handset.
From the inside:
o
Enter the internal number of the telephone to be moni-
tored.
or From the outside:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the HiPath 1200. Enter the station num-
ber (DISA MSN; consult service personnel).
o
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN
Æ page 72.
o
Enter the internal number of the telephone to be moni-
tored.
Program/Service
*88=Room monitor?
Program/Service