Siemens HIPATH 1200 - Manual (Page 18)

Step by Step
Making Calls – Basic Functions
18
The other party answers with speaker:
n
Lift the handset.
or On-hook dialing: use speakerphone mode (not available
with optiPoint 500 economy and optiPoint 500 basic).
The called party does not answer or is busy:
Press the key. The LED goes out.
or
Press the key.
Switching to Speakerphone Mode
Precondition: You are conducting a call with the hand-
set.
and
t
Hold down the key and replace the handset. Then re-
lease the key and continue the call.
Switching to the Handset
Precondition: You are engaged in a call in speakerpho-
ne mode.
n
and
s
Lift the handset. Continue the call.
Speaker
Release
Your HiPath 1200 may also be programmed so
that you have to either press the Internal key or
enter the internal code before you dial an internal
number.
To call an external party, you have to enter an ex-
ternal code before dialing the party’s telephone
number (automatic trunk seizure/prime line is not
active; consult service personnel).
When automatic trunk seizure is active, you will
hear a continuous tone when you lift the hand-
set.
This function is not available with
optiPoint 500 economy and optiPoint 500 basic.
Speaker
This function is not available with
optiPoint 500 economy and optiPoint 500 basic.