Sharp Digital Laser Copier/Printer AR-5127 - Manual (Page 48)

AR-5127 SIMULATION 8 - 20
A4/LT (8.5" x 11") detection enable/disable setup
In the inch series, Letter is detected as A4; in the AB series, A4 is detected as Letter.
Detection size when A4/LT (8.5" x 11") document/paper is used.
Operation/procedure
Set the auditor.
Operation/procedure
Used to set the count up number (1 or 2) when an A3/WLT paper
passes through.
For the drum counter and the developer counter, double count is
employed unconditionally.
(Target counter selection)
Used to set the count up number of the selected counter.
Operation/procedure
Select the destination.
Operation/procedure
Input the set value with the 10-key and press the [OK] key.
Set value Setup Remarks
0 Detection invalid Default
1 Detection valid
Employed unit Destination Document size
Set value
0
(Invalid)
1
(Valid)
Document Document
table/SPF AB series A4 A4 LT (8.5” x 11”)
LT (8.5” x 11”) A4 LT (8.5” x 11”)
Inch series A4 LT (8.5” x 11”) A4
LT (8.5” x 11”) LT (8.5” x 11”) A4
Paper Machine paper
feed cassette All destinations
– Set with key operations.
Manual paper
feed tray All destinations
–
Regardless of the simulation
setup.
26-3
Purpose Setting
Function
(Purpose) Used to set the specifications of the auditor. Setting
must be made depending on the use condition of the
auditor.
Section Auditor
Item Specifications
Display
items
Content
Setting
range
Default
0:P10
Built-in auditor mode 0-2 0
1:VENDOR
Coin vendor mode
2:OTHER Others
26-5
Purpose Setting
Function
(Purpose) Used to set the count mode of the total counter and the
maintenance counter.
Item Specifications Counter
1:TOTAL COUNTER Total
2:MAINTE COUNTER
Maintenance
1:SINGLE COUNT
Single count
2:DOUBLE COUNT
Double count
Setting range 1-2
Default 2
(Initial screen) (Input screen)
Sim26-3 AUDITOR SET
AUDITOR 0
(0:P10 1:VENDOR
2:OTHER)
[ 0- 2] 0
Sim26-5 COUNT MODE
1:TOTAL COUNTER 1
2:MAINTE COUNTER 1
2
Sim26-5 COUNT MODE
2:MAINTE COUNTER 1
(1:SINGLE COUNT
2:DOUBLE COUNT)
[ 1- 2] 1
26-6
Purpose Setting
Function (Purpose) Used to set the specifications depending on
the destination.
Item Specifications Destination
Display
items
Content
Setting
range
Default
0:JAPAN Japan 0-13 0
1:SEC SEC
2:SECL SECL
3:SEEG SEEG
4:SUK
SUK
5:SCA
SCA
6:SEF
SEF
7:INEG EX inch series
8:ABEG EX AB series
9:INEF EX inch series (FC)
10:ABEF EX AB series (FC)
11:CHINESE
China
12:TAIWAN
Taiwan
13:SEEG2 SEEG2
26-20
Function
(Purpose) Used to set the job separator paper exit mode.
Sim26-6 DESTINATION
DESTINATION 0
(0:JAPAN 1:SEC
2:SECL 3:SEEG 4:SUK
1/3 [ 0- 13] 0
Sim26-20 JOBSEP OUT
JOBSEP OUT MODE 0
(0:OFF 1:ON)
[ 0- 1] 0