Juniper Networks EX4200 - Manual (Page 207)

To disconnect a Virtual Chassis cable from an EX4200 switch (see Figure 73 on
page 181):
1. Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to the ESD point on the chassis.
2. Loosen the screws on the locking cover by using the cross-head screwdriver.
3. Slide the locking cover back.
4. Gently pull the release pull tab on the Virtual Chassis cable connector to release
the lock holding the Virtual Chassis cable connector in the Virtual Chassis port.
5. Gently pull the Virtual Chassis cable connector out of the Virtual Chassis port.
Figure 73: Virtual Chassis Cable Connector in an EX4200 Switch
NOTE: If you order Virtual Chassis cables separately, you must reuse the locking
covers provided with the original cable or order Virtual Chassis cable locking covers
also separately.
Related Topics ■ Connecting a Virtual Chassis Cable to an EX4200 Switch on page 137
■ Understanding Virtual Chassis Hardware Configuration on an EX4200 Switch on
page 101
■ Understanding Virtual Chassis Components
■ Planning the Virtual Chassis on page 102
■ Virtual Chassis Ports Connector Pinout Information for EX4200 Switches on
page 74
Disconnecting a Virtual Chassis Cable from an EX4200 Switch ■ 181
Chapter 13: Removing Switch Components