Select station name character, Enter new character, Close confirmation screen – JVC SR-VS20EK User Manual
Page 69: Set stations (b)
69
SELECT STATION NAME
CHARACTER
1
Press
#
until the first letter
of the station name begins
blinking.
ENTER NEW CHARACTER
2
Press
%fi to cycle through the characters (A–Z, 0–9, –,
*
, +, (space) ) and stop when the desired character
is indicated, then press
#
to enter. Enter the remaining
characters the same way (maximum of 4).
After entering all characters, press OK.
● The Confirmation screen appears.
● If you make a mistake, press
@
until the incorrect
character begins blinking. Then enter the correct
character by pressing
%fi.
CLOSE CONFIRMATION
SCREEN
3
Press MENU.
Set Stations (B)
Perform steps 1 and 2 of "Storing Channels Manually" on
page 66 to access the Confirmation screen and then
perform steps 1 and 2 of "Set Stations (A)" on page 68
before continuing.
Set station names other than the ones registered in your
recorder.
PR CH
ID
FINE DECODER
06 CH45 BBC1 +/–
OFF
[
5∞] : A-Z, 0-9
[
] : CURSOR
+=
: OK
[MENU] : EXIT
∞
∞
NOTE:
The characters available for the station name (ID) are A–Z, 0–9,
–,
*
, +, (space) (maximum of 4).
1
2
3
4
5
6
7
8
9
1
2
1
2
3
0
3
4
4
OK
MENU