JVC SR-VS20EK - Manual (Page 17)

17
Recording
LOAD A CASSETTE
1
Insert a VHS (or S-VHS) cassette with the record safety
tab intact.
● The recorder power comes on automatically.
The counter is reset to 0:00:00.
SELECT VHS DECK
2
Press VHS.
CHOOSE A PROGRAMME
3
Press PR +/– or the NUMBER keys to select the preset
you wish to record.
SET TAPE SPEED
4
Press SP/LP/EP ( ). Check the SP/LP/EP indicator on
the recorder display panel to confirm the selected tape
speed.
● In EP mode, the recording time is extended three times.
● If you record a programme in EP mode on this
recorder, it is recommended that you play back the
EP-recorded tape on this recorder.
● Picture quality of LP/EP recordings will not be as high
as on SP recordings.
START RECORDING
5
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder. The VHS
record indicator ( ) lights.
● You can not change the preset whilst recording is in
progress. To change the preset, see step 6.
PAUSE/RESUME RECORDING
6
Press PAUSE. Press PLAY to resume recording.
● During the Record Pause mode, you can change the
preset by pressing the PR +/– buttons or the NUMBER
keys.
STOP RECORDING
7
Press STOP. The VHS record indicator ( ) goes off.
Then press EJECT on the VHS deck to remove the
cassette.
1 2 3
4 5 6
7 8 9
1
2
1
2
3
0
3
4
4
5,6
RECORD
5
7
NUMBER
3,6
1
2
5
5,6
3,6
3,6
B.E.S.T. takes place at the beginning of both the
first SP and the first LP (or EP) recording after
inserting the cassette.
PLAY
INFORMATION
You can switch between TV mode and AV mode by
pressing TV/VCR.
* Depending on the type of TV used, TV/VCR button does
not function as described above.
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
(
੬
pg. 11). (Only with a TV offering T-V Link)
6
Turn on the TV and select the AV mode.
EJECT
7
2
4
7
VHS
PAUSE
VHS record indicator
TV/VCR
SP/LP/EP
PAUSE
6
PR+/–
VHS
STOP RECORD
PLAY
PR +/
–
VHS Deck
VHS/S-VHS
To prevent accidental recording on a recorded cassette,
remove its safety tab. To record on it later, cover the hole
with adhesive tape.
Accidental erasure prevention
Record safety tab
STOP