JVC Model 200 - Manual (Page 87)

Chapter 3 Service Adjustments
CRT Holder
Ring
Focus Lock
Screw
Set Screw
Set Screw
CRT Thumb
Screw Guide Plate
CRT Shield
Figure 3-5. CRT Mechanical Focus adjustments.
3.6 CRT Rotation
The CRT tilt adjustment aligns the CRT level with the screen. This
is a factory-set adjustment and should not need adjusting unless
the CRT or yoke is moved.
Remove the rear cover (Section 4.2) and tilt the electronic module
up (Sections 3.3).
1. Select Test Pattern 8, Center/Lin.
2. View the color for the CRT that requires rotation. Hide the other
2 colors.
3. In the Geometry menu, set “Reg Enable” to off by unchecking
the box. Unchecking the Reg Enable box temporarily disables
any convergence corrections that have been performed with a
different CRT/Yoke assembly and sets these values to the
default levels so that CRT Rotation can be accomplished
correctly.
3-8 Model 200 Service Manual