JVC Model 200 - Manual (Page 106)

Chapter 4---Maintenance (Removal/Replacement)
1. Remove the front and rear covers (Section 4.2).
2. Remove the High Voltage Power Supply cover (Figure
4-5) by removing the 2 pozidrive screws that secure
the HVPS at the top of the cover and loosening the 1
pozidrive screw at the bottom of the front flap (Do not
remove this bottom screw-it is difficult to reinstall. The
HVPS will slide up and over it).
Figure 4-5. High Voltage Power Supply cover.
Figure 4-6 High Voltage Power Supply.
3. Carefully slide the cover upward and outward to
remove it.
Model 200 Service Manual 4-9