Juniper Networks JUNOS OS 10.4 - Manual (Page 150)

Table 3: Monitor Ethernet Delay Command Parameters (continued)
Description Parameter Range Parameter
(Optional) Specifies the number of seconds to wait between frames. The
default is 1 second. 1–255 seconds
(default: 1) wait time
If you attempt to monitor delays to a nonexistent MAC address, you must exit the
application manually using ^C:
user@host> monitor ethernet delay-measurement two-way 00:11:22:33:44:55
Two-way ETH-DM request to 00:11:22:33:44:55, Interface ge-5/2/9.0
^C
--- Delay measurement statistics ---
Packets transmitted: 10, Valid packets received: 0
Average delay: 0 usec, Average delay variation: 0 usec
Best case delay: 0 usec, Worst case delay: 0 usec
Related
Documentation
Ethernet OAM •
• Ethernet Frame Delay Measurements on page 125
• Configuring MEP Interfaces to Support ETH-DM on page 128
• Viewing ETH-DM Statistics on page 130
• Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 131
• Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 136
• Configuring ETH-DM with Untagged Interfaces on page 140
Viewing Ethernet Frame Delay Measurements Statistics
Once Ethernet frame delay measurement statistics have been collected, they can be
displayed.
To retrieve the last 100 Ethernet frame delay measurement statistics per remote MEP
or per CFM session, two types of
show commands are provided:
• For all OAM frame counters and Ethernet frame delay measurement statistics
• For Ethernet frame delay measurement statistics only
To retrieve all Ethernet frame delay measurement statistics for a given session, use the
show oam ethernet connectivity-fault-management mep-statistics maintenance-domain
name maintenance-association name [local-mep identifier] [remote-mep identifier] [count
count] command.
To retrieve only Ethernet frame delay measurement statistics for a given session, use
the
show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain name maintenance-association name [local-mep identifier]
[remote-mep identifier] [count count] command.
Copyright © 2013, Juniper Networks, Inc. 130
Junos OS 13.1 MX Series 3D Universal Edge Routers Solutions Guide