Juniper Networks JUNOS OS 10.4 - Manual (Page 114)

}
Router CE2
Configuration
Configure the dual-tagged Ethernet interface.
[edit]
interfaces {
ge-0/0/0 {
flexible-vlan-tagging;
encapsulation flexible-ethernet-services;
unit 0 {
vlan-tags outer 100 inner 34;
family inet {
address
30.1.1.10/24;
}
}
}
}
You verify your configuration on the MX Series router with the show connections command:
user@PE2> show connections
CCC and TCC connections [Link Monitoring On]
Legend for status (St) Legend for connection types
UN -- uninitialized if-sw: interface switching
NP -- not present rmt-if: remote interface switching
WE -- wrong encapsulation lsp-sw: LSP switching
DS -- disabled tx-p2mp-sw: transmit P2MP switching
Dn -- down rx-p2mp-sw: receive P2MP switching
-> -- only outbound conn is up
<- -- only inbound conn is up Legend for circuit types
Up -- operational intf -- interface
RmtDn -- remote CCC down tlsp -- transmit LSP
Restart -- restarting rlsp -- receive LSP
Connection/Circuit Type St Time last up # Up
trans
rws1 rmt-if Up May 13 11:25:40
1
ge-0/2/0.0 intf Up
lsp2-1 tlsp Up
lsp1-2 rlsp Up
Configuring Router PE2 with a Remote Interface Switch over Aggregated Ethernet
Router CE1
Configuration
The configuration of the remote interface switch is based on RSVP-signaled MPLS
connections.
Configure Ethernet over ATM on the ATM interface.
[edit]
interfaces {
at-2/0/0 {
encapsulation ethernet-over-atm;
atm-options {
vpi 100;
}
Copyright © 2013, Juniper Networks, Inc. 94
Junos OS 13.1 MX Series 3D Universal Edge Routers Solutions Guide