Side / rear, Side / rear i, Cation – JVC VN-C20 User Manual
Page 9
9
Side / Rear
I
[RESET] Reset button
This is a button for rebooting the camera. Press
this button and release within 5 seconds to
reboot the camera.
It takes about 1 minute for the camera to
reboot.During startup, [RESET] button is
disabled.
Cation:
Pressing the [RESET] button for 5 seconds or
longer switches the camera to the service
verification mode.
Do not press the button for 5 seconds or longer.
J
[IRIS] Iris terminal
Use this terminal to connect the DC iris lens.
(Connection with the video iris lens is not
possible.)
(
K
[POWER] Power indicator
This indicator appears blinking when the power
is turned on and lights up when the camera
startup is completed. Check the camera or the
connected device if the indicator remains
blinking when the camera is in use.
L
[VIDEO OUT] Coaxial Cable Terminal
This is an output terminal for composite video
signals (1 V (p-p), output impedance of 75
K).
Use this terminal to connect to video monitor,
etc.
(
M
[10BASE-T/100BASE-TX] 10BASE-T/
100BASE-TX terminal
Use this terminal to connect to the network using
a LAN cable.
This product supports PoE (IEEE802.3af) and
therefore can be used without a power cable.
(
N
[ALARM INPUT/OUTPUT] Alarm input/
output terminal
Use this terminal to connect to an external alarm
device.
(
O
[AC24V] AV24V Power terminal
Use this terminal to connect to an AC24 V, 50
Hz/60 Hz power supply.
(
CLASS
2
O
NL
Y
For
USA
ISOLA
TED
P
O
W
ER
ONL
Y
For
E
UR
OPE
and
O
THER
POWER
CAUTION: Do not use
PoE and AC24V together
VIDEO OUT
10BASE-T/100BASE-TX
G
2
1
2
1
2
1
ALARM
OUTPUT
Po
E
INPUT
A
C24V
RESET
IRIS
PUSH
DO NOT CONNECT TO THE
TELEPHONE NETWORK
J
O
N
I
L
M
K
VN-C20_EN.book Page 9 Tuesday, January 31, 2006 1:51 PM