JVC VN-C20 - Manual (Page 62)

62
Operation (continued)
Setting Up the Internet Explorer
(continued)
3.
If Active scripting of the Internet Explorer is disabled, follow the steps below to enable it
● Click [Trusted sites] under [Tools]−[Internet Options]−[Security]. Upon doing so, the [Sites...]
button directly below becomes active. Click on this button and deselect the check in the displayed
window. Next, add the IP address of VN-C20.If the setting is factory default, add the following
web site to the zone.
http://192.168.0.2
● Click [Trusted sites] under [Tools]−[Internet Options]−[Security]. Select the [Custom Level] button
and open the ASecurity SettingsB window. From the opened window, set all the items in [Actine X
controls and piug-ins] to [Enable].
4.
If the pop-up block function of the Internet Explorer is enabled, follow the steps below to
disable it
T The built-in viewer cannot be used when the pop-up block function is enabled.
● Selecting [Tools]−[Pop-up Blocker]−[Turn Off Pop-up Blocker] permits all sites.
● To allow only specific sites such as VN-C20, select [Tools]−[Pop-up Blocker]−[Turn On Pop-up
Blocker], followed by selecting [Tools]
−[Pop-up Blocker]−[Pop-up Blocker Settings] that becomes
active, and open the APop-up Blocker SettingsB window. In the opened window, add the address
of VN-C20 as an allowed web site address.
5.
When plug-in tools such as the Yahoo or Google toolbar are included in the Internet Explorer,
disable the pop-up block function of these plug-in tools as well
Operation of Built-in Viewer
(continued)
VN-C20_EN.book Page 62 Tuesday, January 31, 2006 1:51 PM