JVC VN-C20 - Manual (Page 12)

12
Introduction (continued)
Step 1 Connection / Installation( A Page 13)
G
Step 2 Network Settings( A Page 21)
T In a system where multiple units of VN-C20
are used, turn on the power of only 1 unit to
configure the IP address settings via the
Internet Explorer. Upon doing so, turn on the
power of the second unit and configure
accordingly. Configure the camera settings
using the same procedure.
G
Step 3 Setting Using Internet
Explorer(
A Page 27)
G
Step 4 Operation of Built-in
Viewer( A Page 60)
Setup Procedures
Mount the lens, and connect the power supply
cable, LAN cable and alarm.
Next, mount the camera to the ceiling.
Remember also to mount the fall-prevention
wire. After the camera is mounted, connect the
monitor TV to the VIDEO OUT terminal at the
rear of the unit, followed by adjusting the
camera angle.
(Back focus adjustment
A Page 19)
Configure the network settings of the
computer and this camera.
Configure the picture quality and alarm
settings using the Internet Explorer.
Monitoring and still image saving operations
are possible using the built-in viewer of this
camera.
VN-C20_EN.book Page 12 Tuesday, January 31, 2006 1:51 PM