JVC GY-HM700CHE - Manual (Page 127)

123
Tally Lamps
The tally lamps start blinking when the remaining space on the SDHC card is running out during recording, or when the battery
power is running low.
Alarm Tone
Alarm tone is output from the monitor speaker and [PHONES] terminal when the battery level is low.
Alarm tone is output from the monitor speaker and [PHONES] terminal when the SDHC card is full. (Camera mode only)
Alarm tone is also output when an error occurs in the camera recorder.
Memo:
● [Alarm Level] in the [Others] menu can be used to specify whether alarm tone is to be output, as well as the volume level.
(A Page 87)
● Alarm tone is not output during recording.
Error Display
Status Action
Status Screen
Menu/Thumbnail
Screen
EXT-RECORDER
POWER ?
^ Power of the camera recorder is turned off
while the external device connection is
detected, and the same connection cannot be
detected several seconds after power is turned
on again. (Error displays for about 7 seconds) When making use of a connected external
device, turn on the power supply on the
connected device.
VIDEO FORMAT
INCORRECT
^ ● Video format of the file for Clip Review is
different from the [Frame & Bit Rate] setting
of the camera recorder.
● IEEE1394 input video format is different
from the [Camera Resolution] and [Frame &
Bit Rate] settings.
Set [Camera Resolution] and [Frame & Bit
Rate] correctly. (A Page 71)
● [HD/DV] terminal mode switch is not
correctly set for IEEE1394 input signals.
Set the [HD/DV] terminal mode switch
according to the IEEE1394 input signals
correctly.
MEDIA FULL ^ ● [REC] button is pressed when the media in
use has no remaining space.
● Remaining space ran out during recording.
Replace the SDHC card with a new one.
FAN MAINTENANCE
REQUIRED
^ ● Usage time of the fan has exceeded 9000
hours.
Check the fan and replace accordingly. For
more details, consult your nearest JVC dealer.
Memo:
● You can check the usage time of the fan at
[Others]B[System Information]B[Fan Hour].
(A Page 88)
Blinking Mode Remaining Battery Power/SDHC Card Space
Blinks slowly
(Once every second)
● Battery power is low
● Remaining recording time on SDHC card is less than 3 minutes
Blinks quickly
(4 times a second)
● SDHC card is full
● Error on the camera recorder