IBM RS/6000 SP - Manual (Page 72)

Table 3-1. Service procedure tools
Utility (see note) Runs on Description
fault_service_Worm_RTG All nodes Monitors the switch for faults. It restarts the switch if a
fault is detected.
fs_monitor All nodes Monitors the adapter for interrupts that have not been
serviced. This is required because of a hardware
oversight in MSMU, in which there is a window in time
that causes it to hold interrupts and then forget to
introduce them.
rc.switch All nodes Starts the daemons and IP configuration tools.
Estart Primary or
Control Node Tunes the switch and puts it into run phase. Also, kicks
off the route table generator and distributes the routes to
the nodes, by placing them in the etc/SP directory on
the control node.
Estart_sw Primary or
Control Node This is the primary-node command to start the RS/6000
SP High Performance Switch. Estart_sw is called by
Estart. It is useful to note that the time-out variable
(LIMIT) for the Estart process is located in this file. This
may have to adjusted for systems that take longer to
tune than in other systems.
Eprimary All nodes Sets a node as the primary node.
Eprotocol All nodes Stores switch protocol information in the System Data
Repository for a node or a series of nodes. Also
retrieves a topology files out of the SDR.
Eclock Primary or
Control Node Controls the clock source for each switch board within
an SP cluster.
ifconfig All nodes This sets up the IP interface to the switch.
Note: Unless otherwise noted, the directory for these utilities is /usr/lpp/ssp/css.
Table 3-2. Setup output files
File (see note) Location Description
rc.switch.log All nodes Logs all information on the last run of rc.switch. It will
indicate if this is a primary or secondary node, the
associated switch chip information, and IP address
information.
rc.switch.log.previous All nodes A copy the previous run of rc.switch.
expected.top.no_comments All nodes Used by rc.switch to more easily parse out chip
connection information.
fs_daemon_print.file All nodes A log of the daemon.
fs_monitor.log All nodes A log of the monitor daemon.
css.snap All nodes Log files created by the switch support code.
Note: The directory for these utilities is /var/adm/SPlogs/css.
Table 3-3. Tuning output files
File (see note) Location Description
daemon.stdout Primary Keeps a detailed account of the tuning process initiated by the
Estart command. It includes data from every tuning operation
since the current daemon on the primary node was initiated.
daemon.results Primary A record of how many nodes were initialized.
3-2 RS/6000 SP: SP Switch Service Guide