Integra DTR-6.8 - Manual (Page 117)

117
Controlling Other Components
—Continued
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to con-
trol components that are out of view, in a rack, for exam-
ple.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not con-
nected via
, use the following remote control codes:
• [DVD] Remote Mode button
5001: Integra/Onkyo DVD player without (default)
• [CD] Remote Mode button
6001: Integra/Onkyo CD player without (default)
• [MD] Remote Mode button
6007: Onkyo MD recorder without
• [CDR] Remote Mode button
6005: Onkyo CD recorder without
• [Dock] Remote Mode button
6003: Onkyo RI DOCK DS-A2 without (default)
Note:
If you connect an
-capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote opera-
tion to work properly, you must set the Input Display to
MD or CDR, respectively (see page 48).
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Integra/
Onkyo Components Connected via
1 Make sure the Integra component is con-
nected with an
cable and an analog
audio cable (RCA).
See page 41 for details.
2 Enter the appropriate remote control code
for the Remote Mode button.
• [DVD] Remote Mode button
5002: Integra/Onkyo DVD player with
• [CD] Remote Mode button
6002: Integra/Onkyo CD player with
• [MD] Remote Mode button
6008: Onkyo MD recorder with
• [CDR] Remote Mode button
6006: Onkyo CD recorder with
• [Dock] Remote Mode button
6004: Onkyo RI DOCK DS-A1 with
See the previous page for how to enter remote
control codes.
3 Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
Resetting Remote Mode Buttons
1 While holding down the Remote
Mode button that you want to
reset, press the TV [
] button.
The Remote indicator flashes three
times.
2 Press the Remote Mode button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra/Onkyo DVD players and CD
players respectively. When these but-
tons are reset, the preprogrammed
code is restored.
Resetting the Remote Controller
1 While holding down the
[Receiver] Remote Mode button,
press the [Standby] button.
The Remote indicator flashes five
times.
2 Press the [Receiver] Remote
Mode button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
DTR-6.8_En.book Page 117 Wednesday, June 20, 2007 11:55 PM