Integra DTR-6.8 - Manual (Page 112)

112
Zone 2
—Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Note:
While Powered Zone 2 is being used, listening modes
that require surround back speakers (6.1/7.1), such as
Dolby Digital EX, DTS-ES, and THX Select2 Cinema,
are unavailable.
Controlling Zone 2 with the Remote
Controller
Note:
• To control Zone 2, you must press the remote control-
ler’s [Zone 2] button first.
Using Zone 2
1 To turn on Zone 2 and select an
input source, press the [Zone 2]
button repeatedly.
Alternatively, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on, the Zone 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
To select AM or FM press the [Tuner]
input selector button repeatedly (On the
North American model, you can also
select XM or SIRIUS).
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Z2 Sel: Source”
appears.
2 To turn off Zone 2, press the
Zone 2 [Off] button.
1 2
1 Press the [Zone 2] button, then
point the remote controller at the
AV receiver and press the [On]
button.
Zone 2 turns on, the Zone 2 indicator
lights up, and the ZONE 2 12V TRIG-
GER OUT goes high (+12 V).
2 To select an input source for
Zone 2, press the [Zone 2] button,
followed by an Input Selector but-
ton.
To select AM or FM press the [Tuner]
Input Selector button repeatedly (On
the North American model, you can
also select XM or SIRIUS).
3 To turn off Zone 2, press the
[Zone 2] button, followed by the
[Standby] button.
Input
Selector
On
Level –/+
Zone 2
DTR-6.8_En.book Page 112 Wednesday, June 20, 2007 4:16 PM