IBM HANDBOOK 260 - Manual (Page 221)

Service Processor 203
7.5.5.1 Modem Configuration Menu
The first two lines of the Modem Configuration Menu (shown following) are
status lines showing the current selections. Selections are made in the two
sections labeled Modem Ports and Modem Configuration File Name. Select
the serial port that you want to activate and then select the modem
configuration file for the modem on the port. If you wish to set up both serial
ports with modems, make your selections one port at a time.
To configure the modem, you first have to choose the serial port on which
your modem is connected to the system. Press 1 or 2 for the appropriate
CALL-IN/CALL-OUT SETUP MENU
1. Modem Configuration Menu
2. Serial Port Selection Menu
3. Serial Port Speed Setup Menu
4. Telephone Number Setup Menu
5. Call-Out Policy Setup Menu
6. Customer Account Setup Menu
7. Call-Out Test
8. Ring Indicate Power-On Menu
98. Return to Previous Menu
99. Exit from Menus
1>
Modem Configuration Menu
Port 1 Modem Configuration File Name:
Port 2 Modem Configuration File Name:
To make changes, First select the port and then the configuration
file name
Modem Ports:
1. Serial port 1
2. Serial port 2
Modem Configuration File Name:
3. none
4. modem_f_sp
9. modem_m0_sp
5. modem_f0_sp 10. modem_m1_sp
6. modem_f1_sp
7. modem_z_sp
8. modem_z0_sp
30. Save configuration to NVRAM and Configure modem
98. Return to Previous Menu
1>