IBM HANDBOOK 260 User Manual
Page 219
Service Processor
201
Configured by System
The processor is present, and has not exceeded
the number of failures threshold. It is configured
by the system and is available.
Deconfigured by System
The processor is present, but has exceeded the
number of failures threshold. It is deconfigured
by the system and is currently unavailable.
Manually configured
The processor is present and available. It is
configured by the user through the Service
Processor menus.
Manually deconfigured
The processor is present, but unavailable. It has
been deconfigured by the user through the
Service Processor menus.
7.5.3.9 Memory Configuration/Deconfiguration Menu
This option allows you to see and modify memory configuration. The following
is an example of the Processor Configuration/Deconfiguration Menu:
You can manually configure or deconfigure any memory DIMM, regardless of
failure status, through this SP menu. The configuration process takes place
during the system power-up. Therefore, the configuration displayed in
You can also disable the second processor with the following steps:
1. Power-on the system and go into the Open Firmware mode (see 6.7.1,
2. After the
ok>
prompt appeared enter: boot -scpu=1
This will automatically disable the second processor and cause the system
to continue the boot process. After a reboot the second processor will be
automatically enabled by the system.
Note
MEMORY CONFIGURATION/DECONFIGURATION MENU
DIMMs on Memory Card #0:
DIMMs on Memory Card #1:
1. Configured by system (0x0)
98. Return to Previous Menu
Enter card number _AND_ DIMM number separated by a space.
1>