IBM 704 - Manual (Page 142)

Removing Memory-Module Kits
Removing Memory-Module Kits
16
Attention:
a. Reduce the risk of electrostatic discharge (ESD) damage
to the memory modules and memory board by following
the instructions in Notice Number 10.
b. To avoid breaking the retaining clips or damaging the
sockets, handle the clips gently.
1. Remove the board-support panel:
a. Remove the left side panel 1 .
b. Remove the four screws 2 from the right edge of the
board-support panel. Save the screws for later use.
1
2
c. Open the board-support panel.
d. Remove the board-support panel by pulling the back edge
away from the three slots at the back of the chassis.
e. Store the panel until you are ready to reinstall it.
124 PC Server 704 User's Handbook