System menu – MITSUBISHI ELECTRIC DX-TL4516U User Manual
Page 78
75
Operations
Memory
System Menu
Add/Remove HDD Device
This item is used to set the HDDs for main or copy device.
You cannot set this item during recording or playback.
Memory
5
steps
1, 2
steps
3, 4
1
1
2
Add/Remove HDD Device
Internal HDD
External HDD (USB HDD)
System Menu
[Internal HDD]
step
1. Make sure that the internal HDDs connected are
displayed in the screen of
• Internal A and B indicate the internal device
number.
step
2. Add or remove the internal HDDs for setting the
main device or copy 2 device.
Main: Registers for the main device. The numbers
01 and 02 indicate the recording order.
Copy2: Registers for the copy 2 device. The
numbers indicate the order for writing of data. Do
not set all the internal HDDs to copy 2 device.
Free: Does not registered as the main device.
• The button changes in the order of “Main,”
“Copy2,” and “Free” each time you press the
button.
[External HDD]
step
3. Make sure that the USB HDDs connected to the
SERIAL BUS port of this unit are displayed in the
screen of
• When the “SB:” button of the desired ID number
is pressed, the access LED on the device
illuminates and you can check the corresponding
HDD which is connected to the SERIAL BUS
port.
step
4. Add or remove the USB HDD for setting the main or
copy device.
Main: Registers for the main device. The numbers
indicate the recording order.
Copy1: Registers for the copy 1 device. The
numbers indicate the order for writing of data.
Copy2: Registers for the copy 2 device. The
numbers indicate the order for writing of data.
Free: Does not registered as the main or copy
device.
• The button changes in the order of “Main,”
“Copy1,” “Copy2,” and “Free” each time you
press the button.
The available devices to be set as the copy 1 device are:
HDD, DVD-R, DVD-RW, CD-R, CD-RW and USB memo-
ry.
The available devices to be set as the copy 2 device are:
HDD, DVD-RW, DVD-R, CD-R, and CD-RW.
The copied data is transmitted in 2 MB units. The copy of
up to 2 MB of the latest data may be delayed. Be careful
when changing the copy device.
The maximum number of devices connected to serial bus
is 16 including the built-in DVD and USB memory. This is
the total number of devices of main, copy 1, and copy 2.
The order of the main device used for recording is:
internal HDD USB HDD.
The maximum number of HDDs used as main device is
16 including internal HDD. (This is the total number of
HDDs of internal and serial bus.)
HDD used as copy 2 device is selected from either of
internal and serial bus.
The registered information may not be displayed correctly
during operation such as recording or playback.
USB memory is usable only when the HDD is registered
for main device.