Flowchart – MITSUBISHI ELECTRIC DX-TL4516U User Manual
Page 14
10
Connections
• Connections for camera, monitor, and sensor.
See “ Connecting to CCTV camera, monitor,
and sensor” on page 18.
• Connection for the alarm recording.
See “ Alarm recording connection” on page
19 and “ Rear view” on page 16.
Boot-up the unit
When not executing Setup Wizard:
See “
Setup Wizard” on page 26.
Only when the unit is turned on for the first time, the
is not displayed next time.
• Set the present time and HDD settings in each menu
manually. (“ Time/Date Setting” on page 58. Set
the present time. “ Data Management Setting for
Main Memory” on page 77. Set the alarm area.)
Recording
Flowchart for connection and settings
This is a flowchart of connection and settings for making an alarm recording with timer recording and then search, playback,
and copy the recorded data.
Flowchart
Connections
• Connections for camera, monitor, and sensor.
See “ Connecting to CCTV camera, monitor,
and sensor” on page 18.
• Connection for the alarm recording.
See “ Alarm recording connection” on page
19 and “ Rear view” on page 16.
Boot-up the unit
When executing Setup Wizard:
See “
Setup Wizard” on page 26.
Only when the unit is turned on for the first time, the
is not displayed next time.
• The language, present time, HDD configuration, and
recording settings are set automatically by following
the instructions in the menu.
Making the initial menu settings
• Setting the present time display mode.
See “ On Screen Information” on page 67.
• Setting the audio recording.
See “ Audio Recording Setup” on page 53
and “ Continuous recording time table” on page
105.
Making the HDD settings
• Setting the repeat recording.
See “ Data Management Setting for Main
Memory” on page 77.
• Setting the remaining HDD capacity.
See “Low Memory Alarm Setting” on page 58
• Setting the CALL OUT.
See “ Call Out Settings” on page 59.
• Setting the buzzer.
See “ Buzzer” on page 59.
Making the multiplexer settings
• Making the split screen settings.
See “ Multiplexer Setting” on page 64.
• Making the sequence setting.
See “ Multiplexer Setting” on page 64.