Milan Technology MIL-SME801P - Manual (Page 99)

93
5-2. Port Status
State: Displays port status off or on depending on user setting. “Unlink”
means the port is offline or “off ”.
Link Status: Down is “No Link”, UP is “Link”.
Auto Negotiation: Displays the auto negotiation mode. There are three
selections: Auto, Force and Nway-force.
Speed status: Displays link speeds of 100Mbps or 10Mbps.
Duplex status: Displays full-duplex or half-duplex mode.
Flow Control: Displays the flow control status as enabled or disabled in
full-duplex mode.
Backpressure: Displays the backpressure status as enabled or disabled in
half-duplex mode.
Rate Control: Displays the rate control setting.
Ingr: Displays the port effective ingress rate of user settings in
increments of 100 Kbps.
Egr: Display the port effective egress rate of user settings in
increments of 100 Kbps.
Priority: Displays the port static priority status as High or Low or Disabled.
Port Security: Displays the port security as enabled or disabled.
Config: Displays the setting configured by the user.
Actual: Displays the negotiation result.