Milan Technology MIL-SME801P - Manual (Page 66)

60
4-4-1-3. STP Per Port Setting
State: Spanning tree status for each port is either forwarding or blocking.
PathCost: Specifies the path cost of the port that the switch uses to
determine which ports are the forwarding ports. If you change the value, you
need to restart the switch for valid value change to take effect .
Priority: Specifies the path cost of the port that the switch uses to determine
which ports are the forwarding ports. The lowest number is picked as the
forwarding port. The range is 1-65535 and the default value is based on
IEEE802.1D standard. The values should be in the range: 10Mb/s =
50-600 100Mb/s = 10-60.
If you change the value, you must reboot the switch to save the value change.