beautypg.com

MITSUBISHI ELECTRIC 700 Series User Manual

Page 103

background image

98

Instruction Format

(3) Source (S)

The source contains the data to be used for operation.
The data changes depending on the specified device.

(4) Destination (D)

The destination stores the data resulting from operation. Note that if the format

consists of

+

+

,

the data to be used for operation must have been stored into the destination
before operation.
At the destination, always specify the device for storing data.

• Constant .................................. Specify the numerical value to be used for

operation. Since this value is set at the time of
program creation, it is fixed and cannot be
changed during program execution.

• Bit device .................................

Word device

Specify the device that stores the data to be
used for operation. Therefore, the data must
have been stored into the specified device until
operation is executed. By changing the data
stored into the specified device during program
execution, the data used for that instruction can
be changed.

REMARKS

In this manual, the source and destination are abbreviated as follows.

Source................................

Source 1.............................

Source 2.............................

Destination .........................

Destination 1 ......................

Instruction part

Source device

Destination device

S

S1
S2

D

D1