Gateway Profile 6 - Manual (Page 59)

www.gateway.com
53
6 Remove the seven screws that secure the system board
to the case.
7 Slide the system board to the right until it slides free
from the case, then remove it completely from the case.
8 Slide the new system board into place, then replace the
seven screws you removed previously.
9 Replace the heat sink and tighten the four captive
screws.
10 Replace the processor fan by following the instructions
in
“Replacing the processor fan” on page 37 .
11 Replace the riser card assembly by following the
instructions in
“Adding or replacing an expansion card”
on page 47 .
12 Replace the back panel by following the instructions in
“Replacing the back panel” on page 36 .
Screws
Screws
8512032.book Page 53 Tuesday, January 9, 2007 1:47 PM