Gateway Profile 6 - Manual (Page 54)

CHAPTER 4: Upgrading Your Computer
48
4 Replace the PCI riser card by sliding it back into place.
5 Replace the back panel by following the instructions in
“Replacing the back panel” on page 36 .
Installing a full-height expansion card
To install a full-height expansion card:
1 Remove the back panel by following the instructions in
“Opening the case” on page 35 .
2 Remove the PCI riser card by pulling on its green handle.
3 Press the two tabs on the card retention lever together,
then lift the card retention lever out of the way.
Caution
Do not touch the contacts on the bottom part of the expansion
card. Touching the contacts can cause electrostatic damage to the card.
8512032.book Page 48 Tuesday, January 9, 2007 1:47 PM