Grizzly G0564 - Manual (Page 34)

-32-
Model g0563/g0564 (Mfg. since 10/11)
figure 36. angle indicator pin screw.
6. align the angle indicator pin with the 90˚ mark
and tighten the angle indicator pin screw.
removing Drive
roller
the Model g0563/g0564 comes equipped with
a puller to remove the drive roller should it ever
become necessary to do so.
tools needed:
Cap screw
5 /
16
-18 x 1 1 /
4
...................................... 1
Cap screw 1 /
4
-20 x 1 3 /
4
...................................... 2
drive puller plate ............................................... 1
hex wrench 5mm .............................................. 1
hex wrench 6mm .............................................. 1
socket
7 /
8
" .......................................................... 1
ratchet w/6" extension ...................................... 1
to remove the drive roller:
1. remove the hex nut and lock washer secur-
ing the driver roller to the shaft.
2. thread the two 1 /
4
-20 x 1 3 /
4
cap screws on the
puller four turns into the threaded holes in the
drive roller.
3. thread and tighten the 5 /
16
-18 x 1 1 /
4
cap
screw the puller, shown in figure 37, until
the drive roller is pulled.
figure 37. using the drive roller puller.
4. to re-install, place the drive roller on the
shaft, and thread the lock washer and hex nut
onto the shaft and tighten securely.
notE—Do not hammer the drive roller onto
the shaft or you will cause damage to the
shaft.