Grizzly G0564 - Manual (Page 17)

Model g0563/g0564 (Mfg. since 10/11)
-15-
figure 6. Belt tensioning lever in the released
position.
components and hardware needed: Qty
sanding Belt .......................................................1
to install the belt:
1. open the belt access door by removing the
star knobs and opening all latches.
2. lift the belt tensioning lever as shown in
figure 6.
Installing belt
the unpainted surfaces of this machine are
coated with a waxy oil for protection from cor-
rosion during shipment. remove it with a sol-
vent cleaner or citrus-based degreaser such as
grizzly’s g7895 degreaser. to clean thoroughly,
some parts may need to be removed.
For optimum performance from your machine,
make sure you clean all moving parts or sliding
contact surfaces that are coated.
avoid chlorine-
based solvents as they may damage painted
surfaces should they come in contact.
always follow the manufacturer’s instructions
when using any type of cleaning product.
clean up
3. determine the belt direction from the arrow
on the dust port and the access door.
4. Match the arrows on the sander to the arrows
inside the sanding belt, and place and center
the belt on the sanding drums.
5. tension the sanding belt by pushing the belt
tensioning lever down.
6. Close the belt access door, insert the star
knobs, and latch the levers.
7. adjust the belt tracking as described on page
19.