Dust port cover, Dust collection – Grizzly G0564 User Manual
Page 19
Model g0563/g0564 (Mfg. since 10/11)
-17-
Dust port cover
components and hardware needed:
Qty
dust port Cover ................................................. 1
hinge pin ........................................................... 2
tools needed:
hammer ............................................................. 1
to mount the dust port cover:
1. align the dust port cover hinges with the
hinges on the sander.
2. insert the hinge pins through the aligned
hinges, as shown in
figure 9, and tap with a
hammer for full insertion.
figure 9. dust port cover installation.
3. latch the belt access door to the dust port
cover.
Dust collection
there are two 4" dust collection ports for the
sander that should be connected to a dust collec-
tor. the port locations are shown in
figure 10.
components and hardware needed:
Qty
dust Collector .................................................... 1
dust hose 4" ..................................................... 2
hose Clamp 4" .................................................. 4
tools needed
phillips screwdriver ........................................... 1
to connect your machine to a dust collection
system:
1. use a 4" diameter hose and clamps to con-
nect a dust collection system to your dust
ports.
figure 10. g0563/g0564 dust ports.
hinge pins