Grizzly G0564 - Manual (Page 23)

Model g0563/g0564 (Mfg. since 10/11)
-21-
table adjustment
the table on the oscillating edge sander moves
both vertically and horizontally to accommo-
date various workpieces shapes and thicknesses.
adjust the table height periodically to reduce spot
wear of you sanding belt.
to vertically adjust the table:
1. loosen the lock handles that secure the table
height position.
2. turn the table height adjustment wheel shown
in figure 16, clockwise to raise the table or
counterclockwise to lower the table.
figure 16. height adjustment controls.
3. when the desired position is achieved, tighten
the lock handles to secure the table height.
platen angle
adjustment
the sanding angle of the oscillating edge sander
is variable between 0 and 90 degrees.
to adjust the platen angle:
1. loosen the angle adjustment lock handle and
tilt the sander until the pointer is aligned with
the desired angle as shown in
figure 15.
figure 15. adjusted sanding angle.
2. tighten the angle adjustment lock handle.
note —See page 31 to calibrate the angle scale.
lock handles
handwheel