Grizzly G0564 - Manual (Page 29)

Model g0563/g0564 (Mfg. since 10/11)
-27-
3. remove the hex bolts on the opposite side
of the gear box and remove the gear box
cover.
4. remove the oil fill plug on top of the gear box,
as shown in figure 30 and fill with saE 80w
gear oil until the level is 1 /
2
" from the top.
Wear safety glasses dur-
ing the entire mainte-
nance process. failure
to comply may result in
serious personal injury
Lubrication
General
SEctIOn 6: MaIntEnancE
regular periodic maintenance of your Model
g0563/g0564 will ensure optimum performance.
Make a habit of inspecting your machine each
time you use it. Check for the following conditions
and repair or replace when necessary:
1. loose mounting bolts.
2. worn switch.
3. worn or damaged cords and plugs.
4. damaged or worn sanding belt.
5. any other condition that could hamper the
safe operation of this machine.
Disconnect power to the
machine before perform-
ing maintenance, assem-
bly or adjustments.
failure to do so may
result in serious person-
al injury.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
after operating the Model g0563/g0564 for
approximately 500 hours, refill the gear box with
oil.
tools needed:
open End wrench 10mm x 12mm .................... 1
hex wrench 5mm .............................................. 1
grease gun w/all purpose grease ................... 1
oil Can w/light Machine oil .............................. 1
saE 80w gear oil ............................................ 1
to check and refill the gear box:
1. place the belt sander in the horizontal posi-
tion.
2. remove the cap screws on top of the gear
box cover shown in figure 29.
figure 29. gearbox cap screws.