Grizzly G0564 - Manual (Page 18)

-16-
Model g0563/g0564 (Mfg. since 10/11)
back Stop
components and hardware needed: Qty
hex Bolt 5 /
16
-18 x 1............................................. 2
Flat washer 5 /
16
" ................................................ 2
Back stop .......................................................... 1
tools needed:
open End wrench 10mm x 12mm .................... 1
to mount the back stop:
1. place a washer on each hex bolt and thread
them approximately one turn into the holes in
the platen shown in
figure 7.
figure 7. Back stop bolts.
2. slide the back stop onto the hex bolts and
tighten, allowing 1 /
8
" clearance from the belt
to the bottom of the back stop.
components and hardware needed: Qty
dust port ........................................................... 1
phillips head screw
1 /
4
-20 x 3 /
8
.......................... 4
Flat washer 1 /
4
" .................................................. 4
tools needed:
phillips screwdriver ........................................... 1
to mount the dust port:
1. align the dust port holes with the tapped
holes on the side of the sander as shown in
figure 8.
Dust port
figure 8. installing dust port.
2. insert the phillips head screws and washers
through the aligned holes and tighten.