Grizzly G0564 - Manual (Page 24)

-22-
Model g0563/g0564 (Mfg. since 10/11)
Miter Gauge
figure 18. squaring miter gauge to belt.
the miter gauge needs to be adjusted perpen-
dicular to the face of the belt when it is mounted
in the table slot.
to adjust the miter gauge:
1. use a machinist square with one edge
against the face of the miter gauge and
the other against the belt face as shown in
figure 18.
2. loosen the lock knob on the miter gauge to
adjust it flush with the edge of the square.
3. tighten the lock knob, and verify the setting.
note—Sometimes the tightening procedure
can affect the adjustment.
4. loosen the screw that secures the angle
pointer and adjust the pointer to the 0˚ mark
on the scale.
5. retighten the screw that secures the angle
pointer.
to horizontally adjust the table:
1. Move the table lock levers to the loose
position as illustrated by the labels on the
machine.
2. push or pull the table until there is a gap of
no more than 1 /
16
" from the sanding belt as
shown in figure 17.
figure 17. horizontal table adjustment.
3. Move the table lock levers to the locked posi-
tion to secure the table position.
table lock
levers
Minimum
1 /
16
" gap