Grizzly G0564 - Manual (Page 31)

Model g0563/g0564 (Mfg. since 10/11)
-29-
Spindle connector
the spindle connector connects the shafts from
the motor to the gear box and is secured by two
set screws that need to be tightened every time
the gear box oil is filled (every 500 hours).
tools needed:
hex wrench 5mm .............................................. 1
hex wrench 4mm .............................................. 1
open End wrench 10mm x 12mm .................... 1
to secure the spindle connector set screws:
1. refer to Lubrication steps 1 -3 on page 27 to
remove the gear box cover
2. tighten the set screws shown in figure 33.
figure 33. spindle connector set screws.
3. reinstall the gear box cover.
Eccentric
the eccentric on the Model g0563/g0564 is con-
nected to the shaft by a set screw. this set screw
needs to be tightened every time the gear box oil
is filled (every 500 hours).
tools needed:
hex wrench 5mm .............................................. 1
hex wrench 4mm .............................................. 1
open End wrench 10mm x 12mm .................... 1
to secure the eccentric set screw:
1. refer to Lubrication steps 1 -3 on page 27 to
remove the gear box cover.
2. tighten the set screw on the eccentric, shown
in figure 34.
figure 34. Eccentric set screw.
3. reinstall the gear box cover.