Grizzly G0564 - Manual (Page 33)

Model g0563/g0564 (Mfg. since 10/11)
-31-
calibrating angle
Gauge
in order to maintain accuracy and precision with
the oscillating edge sander, periodically calibrate
the angle gauge.
tools needed:
Machinist's square ............................................ 1
straight slot screwdriver ................................... 1
to calibrate the angle gauge:
1. loosen the angle adjustment lock handle.
2. place the machinist's square on the table and
press it against the platen.
3. adjust the platen until it is flush with the
machinist's square as in figure 35.
figure 35. aligning the table to the platen
4. tighten the angle adjustment lock handle.
5. loosen the angle indicator pin screw, shown
in figure 36, a 1 /
2
turn.
always disconnect
power to the machine
before performing ser-
vice adjustments. failure
to do this may result in
serious personal injury.
this section is designed to help the operator with
adjustments that were made at the factory and
that may also need to be made during the life of
the machine.
this section is provided for your convenience—
it is not a substitute for the grizzly service
department. if any adjustments arise that are not
described in this manual, then feel free to call the
grizzly service department at (570) 546-9663.
similarly, if you are unsure of how to perform
any procedure in this section, the grizzly service
department will be happy to guide you through
the procedures or help in any other way.
about Service
SEctIOn 7: SErvIcE