Grizzly H2881 - Manual

Introduction
This rolling-pin style pneumatic drum sander
is perfect for hand contouring and smoothing
projects that are too large to use with a station-
ary sander. Simply chuck the
3 ⁄
8
" spindle into a
portable electric drill, cordless drill or air powered
drill for two-handed control. Choose this 4" x 1
1 ⁄
8
"
diameter size for getting into tight areas. Features
ball bearing handle and air valve for easy bicycle
pump inflation.
Inventory
A. Drum Sander .............................................. 1
B. Spare Valve Cap ........................................ 1
Operation
Slide the sanding sleeve over the drum. Remove
the plastic cap on the handle with a small screw
driver to expose the air valve. Inflate to the desired
pressure. DO NOT exceed 8 PSI!
MODEL H2881
4" PNEUMATIC DRUM
SANDER
INSTRUCTION SHEET
Figure 1. Model H2881.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8119 PRINTED IN TAIWAN
Figure 2. Pneumatic drum sander in action.
OVER INFLATION HAZARD!
Never exceed 8 PSI!
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
RESPIRATORY HAZARD!
Sanding produces fine
dust. Wear the appropriate
protection during use!
4" Aluminum Oxide Sanding Sleeves
H3875 1 1 ⁄
8
" x 4" x 60 Grit
H3876 1 1 ⁄
8
" x 4" x 100 Grit
H3877 1 1 ⁄
8
" x 4" x 150 Grit
H3878 1 1 ⁄
8
" x 4" x 180 Grit
H3879 1 1 ⁄
8
" x 4" x 220 Grit
H3880 1 1 ⁄
8
" x 4" x 320 Grit