Grizzly G0564 - Manual (Page 20)

-18-
Model g0563/g0564 (Mfg. since 10/11)
Sanding Spindle
the Model g0563/g0564 comes with a spindle
sanding attachment for sanding curved surfaces.
the included sanding drums measure 1
1 /
2
", 2",
and 3" in diameter. the spindle table may also be
used on the end of the sanding belt if so desired.
Be sure to periodically adjust the table height to
minimize spot wear on the spindle/belt.
components and hardware needed: Qty
spindle .............................................................. 1
spindle washer
5 /
16
" .......................................... 1
hex head Bolt 5 /
16
-18 x 1 /
2
.................................. 1
spindle table assembly .................................... 1
lock handle ...................................................... 1
sanding drum (dia. of choice) ........................... 1
table insert (dia. of choice) ............................... 1
tools needed:
open End wrench 10mm x 12mm .................... 1
hex wrench 5mm .............................................. 1
phillips screwdriver ........................................... 1
rod 1
to install the sanding spindle:
1. release the belt guard latch, open the cover,
and latch the cover to the belt access door.
2. remove the three cap screws and false
cover from the drum.
3. line up the screw holes and place the spin-
dle into the drum.
4. thread the cap screws removed in step 2
into the drum and tighten evenly and securely
as shown in
figure 11.
5. slide a sanding drum onto the spindle, and
insert the spindle washer and hex bolt into
the top of the spindle.
6. insert the rod into the side of the spindle to
anchor it and tighten the hex bolt as shown in
figure 12.
7. insert spindle table assembly shaft into the
opening in the idler roller bracket.
8. thread the table lock handle into the pre-
tapped hole in the idler roller bracket. note —
the handle is spring loaded and can be used
as a ratchet.
9. remove the 4" table insert by removing the
three flat head screws in the insert.
10. replace with the table insert that matches the
sanding drum diameter. tighten with the flat
head screws removed in
step 9.
figure 11. tightening cap screws.
figure 12. using the rod to anchor the spindle.