Grizzly 50/65 Ton Ironworker G0646 - Manual (Page 39)

G0646/G0647 50/65 Ton Ironworker
-37-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check:
•
Loose mounting bolts.
• Damaged tooling.
• Worn or damaged wires.
• Operating temperature of hydraulic fluid.
• Any other unsafe condition.
Daily Maintenance:
• Check/fill hydraulic reservoir level.
• Check/fill lubricant in beam one-shot oiler.
• Clean and protect all unpainted surfaces and
tooling.
Monthly Maintenance:
•
Lubricate as necessary (refer to Lubrication
on Page 38).
• Clean built-up grime and debris from inside
cabinet and off motor.
Quarterly Maintenance:
•
Check/adjust beam alignment.
Annual Maintenance:
•
Drain, clean, and re-fill hydraulic system.
Schedule
Wipe away built-up grime and debris from all sta-
tions, tables, and tooling. Clean away any remain-
ing material with a solvent or mineral spirits prod-
uct such as the cleaner/degreaser from Grizzly
shown in
Figure 9 on Page 15.
When thoroughly clean and dry, protect the
unpainted metal surfaces with an application of
products like G96
® Gun Treatment, SLIPIT ® , or
Boeshield ® T-9 (see Section 5: Accessories on
Page 35 for more details).
At least once a month, open the bottom access
panels and clean off debris and grime from the
motor, pump, ram assembly, reservoir, and limit
stop assemblies.
Cleaning &
Protecting