Enter program mode, Exiting from the program mode, Add pin codes – Gianni Industries DK100 User Manual

Page 3: Changing the master codes

Enter Program Mode

1. Compose twice the master code (Factory master is 「12345」)→ (2 beeps), LED: yellow →

"programming mode"

2. Attention:

If the system is not entered any codes or data in 60 seconds, it will exit from the programming
mode automatically.

After 30 wrong codes attempts to enter the master code, the lockout facility will operate for 60
seconds. (Keypad flashes with blue back light)

Exiting from the program mode

Press「＃」 to exit from the programming mode.

Add PIN codes

Enter the Programming modeÆ Enter the slot position code 「＊001~＊099」Æ (beep)Æ????? (Enter
5 digital PIN codes) Æ (beep) ÆEnrolled.
Please repeat the procedure to set another user PIN code.
Press 「＃」 to exit from the programming mode, or program other operating.

Remarks:

The codes「00000」、「1234」、or master code「12345」are not used to be PIN code.

To Set Time delay for Opening door

Enter the Programming modeÆ「＊100」Æ (beep)Æ01~99 ( Pressing 05 represents for 5
seconds)Æ ( 2 beeps)ÆEnrolled.
Press 「＃」 to exit from the programming mode, or program other operating.

Press 00 for the time delay to be “Latch mode”: The first time PIN codes are entered, the relay
changes from N.C. to N.O. (Red LED lights up); The second time PIN codes are entered, the
relay changes from N.O. to N.C. (Red LED extinguished)

To Delete a User Code

Enter the Programming mode→ Press the slot position code of your choice to delete (e.g. "06")
→Press「＊006」→ (beep)Æ「00000」→ (beep) →deleted
Press「#」 to exit from the programming mode, or programming other operating.

Changing the Master codes

Enter the Programming modeÆ Enter「＊000」Æ (beep)ÆPress the 5 digits to be the new master
code→（beep）→Enrolled
Press 「#」 to exit from the programming mode, or program other operating.

Master Code reset to default value 「12345」,

Insert the jumper RESETÆ 1-2 positionÆ (5 beeps)Æreset successfullyÆ Insert the jumper to 2-3
positions to back to normal operation mode.

Remarks: The occupied PIN codes can’t be the master codes.