Gianni Industries Easiprox - Manual

Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-EASIPROX Ver. F Published on 2011.02.14 Page: 1/ 4
EASIPROX
Stand Alone Reader
Operation Manual
114
Unit: mm
EASIPROX EASIPROX-ANSI EASIPROX-980-40
I. Features
1. Memory volume up to 2000 proximity cards/tokens. Reading time approx. 0.5 seconds.
2. Programming via Master Card.
3. Preventing re-entering the same card.
4. Non-volatile memory stores all cards even in the event of total power failure or when the reader is
not in use for a long time.
5. Epoxy sealed. Standard size of single-gang box.
II. Specification
Operating Voltage 12 VAC/VDC
Current Draw Pull In: 70 mA/12 VDC; Holding: 45 mA/12 VDC
RF Frequency 125 KHz (ABA form code)
Read Range 10~15 cm (depending on local installation conditions)
Input 1 contact for Request-To-Exit button
Output 1 relay (Dry contacts: N.O./N.C./Com.)
LED Status Indication 2-LED indicators (Yellow & Green / Red); 3-LED indicators
(Yellow, Green, Red)
Memory Volume 2000 proximity cards/tokens
Format EM-400x 64-bit Standard R/O or Compatible
Relay Rating Max. 5A/250 VAC
Relay Strike Time 0.7 ~ 42 seconds
Ambient Humidity 5%~95% (Non-condensing)
Operating Temperature -20°C~70°C
EMC Specification Meet CE requirement
III. LED Status Indication
Mode Signal Status
Yellow & Green LED flash No Master Card (empty memory)
Yellow LED On Standby
Green LED On Relay strike time
Standby
Red LED On Invalid card
Green LED flash Add cards
Red LED flash Delete cards
Yellow & Red LED flash Clear memory
Yellow LED flash Adjustment of relock time (1 ~ 60
flashes, 0.7 ~ 42 seconds)
Programming
Green LED flash Clear all memory (including Master
Card)