Gianni Industries GEM DG-100 User Manual

Page 3



Set the Relay Strike Time (In setting mode)

1. Press ＊100

2. Press 05（01~99）(1 beep)

Press 05 will set the relay strike to 5 seconds, relay set to toggle mode

3. Press “#” to exit setting mode

In Toggle mode, the relay will switch between N.C. contact and N.O. contact upon enter PIN once.



Delete PINs (In setting mode)

1. Press ＊006 (e.g. code to delete)

2. Press 0000（1 beep）

3. Press “#” to exit setting mode



Change Master Code (In setting mode)

1.Press ＊000

2. Enter 4-digit new master code (1 beep)

3. Press “#” to exit setting mode



Master Code reset to default value “1234”

1. Insert the reset jumper into 1-2 (5 beeps)

2. Master Code reset to default value “1234” (must release the jumper as soon as 5 beeps, otherwise

could clear all PINs)

3. Insert the jumper back into 2-3

(Note: Only after 5 beeps, the system will execute the reset process)



Master Code reset to default value“1234” and Clear all PINs

1. Insert the reset jumper into 1-2 (5 beeps)

2. Master Code reset to default value“1234”

3. Clear all PINs (wait after 5 seconds) (5 beeps)

4. Insert the jumper back into 2-3