Indicator status & default setting parameters, Operation instruction – Gianni Industries GEM DG-100 User Manual

Page 2

Ⅲ. Indicator Status & Default Setting Parameters

Beep & LED Indication:

Mode

Status

Green On

Relay Strike Time

Red On

Power on

LED

Yellow On

In setting mode

1 Beep

Key press, valid PINs

2 Beeps

Enter or exit setting mode

3 Beeps

Incorrect input

Beep

5 Beeps

Master Code back to 1234 (cleared settings)

Factory Default Setting:

Master Code

1234 (4 digits)

Relay Strike Time

5 seconds

Pressed Key Time Delay

30 seconds

Setting Mode Time Delay

50 seconds

Ⅳ. Operation Instruction



Enter Setting Mode

Enter the master code twice (Default value:“1234”) to enter setting mode (2 Beeps)

Note: 1. After 50 seconds if no data entered, it will automatically exit the setting mode.

2. The controller will be lockout for 60 seconds upon 30 consecutive master codes or invalid

PINs attempt.



Exit Setting Mode

Press # to exit setting mode or after 50 seconds if no data entered, it will automatically exit the setting

mode.



Add new PINs (In setting mode)

1. Enter slot position＊001（＊001~＊099）

2. Enter the 4-digit PINs (1 beep)

3. Press “#” to exit setting mode

Note: 1. “0000”, “1234” and any master code cannot be used for PINs

2. Up to 29-digit-fuzzy-code password protected design

e.g. Press 59632548745233058403256905194→open the door (The valid PINs are “5194”)