Gateway 955 - Manual (Page 65)

59
Installing memory
www.gateway.com
To install or replace memory:
1
Follow the instructions in “Preventing static electricity discharge” on
page 45 .
2
Follow the instructions in “Opening the server case” on page 46 .
3
Pull the plastic tabs away from the sides of the memory module slot. If
you are replacing a memory module, lift the old module out of the slot.
4
Align the notch on the new module with the notch in the memory module
slot and press the module firmly into the slot. The tabs on the sides of
the memory slot should secure the memory module automatically.
5
Follow the instructions in “Closing the server case” on page 48 .
6
Turn on the server, then make sure that the operating system completely
loads. If you receive an error, see
“Memory” on page 108 .